|
Title: Aeon Saber question about sound Post by: Sythen on December 27, 2010, 02:06:06 AM I have a SRD Aeon and it is fantastic and the review is coming in a few hours. I do have one question.
I am planning to install my own FX sound card and it is all ready to go but i have a slight problem. How do i get the electornics in the hilt out. Title: Re: Aeon Saber question about sound Post by: Mikkyo of the Sith on December 27, 2010, 07:27:01 AM I have a V2 Phantom I was curious about doing this to as well. & I didn't want to start a whole new thread, but A: what size is the illuminated hole in the emitter & IS it threaded?
Title: Re: Aeon Saber question about sound Post by: Ultra on December 27, 2010, 09:36:34 AM The decorative hole in the emitter is 6-32 threaded. You can leave it as-is, or add a decorative thumb screw. For liability reasons, we do not encourage nor provide instruction on the disassembly of our sabers, however, I'm sure you can figure it out on your own as it's not too complicated.
|