|
Title: Saber goes into boot up on every power up Post by: Maj pain on October 28, 2017, 09:25:42 AM When I press the switch on power up, I get the initial 'ultrasaber' power up intro , the blade turns on then turns right off instead of powering up and staying on.
Every time I press the button to power on, it's an intro, the blade flashes, then turns off... after doing that a time or two, the blade will then stay on and hum?? What's wrong? Title: Re: Saber goes into boot up on every power up Post by: Akheron on December 07, 2017, 06:01:38 AM If you're sure that the batteries are adequately charged and seated properly in the holder, it sounds like it could be a cold solder joint or breaking wire... but I'm not an expert. What board do you have in it? Do you have a recharge port?
Title: Re: Saber goes into boot up on every power up Post by: tx_tuff on December 07, 2017, 10:10:49 AM If it didn't finally come in I would say it is more batteries. Still might be the cause.
Sent from my XT1650 using Tapatalk Title: Re: Saber goes into boot up on every power up Post by: Darth Logos on December 07, 2017, 02:03:45 PM When I press the switch on power up, I get the initial 'ultrasaber' power up intro , the blade turns on then turns right off instead of powering up and staying on. Do you have V4 sound?Every time I press the button to power on, it's an intro, the blade flashes, then turns off... after doing that a time or two, the blade will then stay on and hum?? What's wrong? |