|
Title: Add sound to lightsaber Post by: fralodia on December 17, 2018, 05:35:48 AM Hi.
I bought my first lightsaber and I did a mistake. I bought Emerald driver (without sound) and I want sound. Is it possible to buy and add to it the "Obsidian USB Soundcard" and a "battery Holder/speaker"? There is any place to see how to do it? Thank you. Jordi Title: Re: Add sound to lightsaber Post by: firehand10k on December 13, 2019, 03:39:06 PM It is possible but takes some know how and skill. It is generally recommended to send it back in to have it done?
Title: Re: Add sound to lightsaber Post by: Infinit01 on December 13, 2019, 06:44:27 PM Hey there, it all depends on your skill with soldering and electronics. Keep in mind that if you do it on your own, you void the warranty so it's probably best if you have UltraSabers do it. Just contact customer service, they'll give you direction
Title: Re: Add sound to lightsaber Post by: chalion on December 13, 2019, 10:12:38 PM Hey there, it all depends on your skill with soldering and electronics. Keep in mind that if you do it on your own, you void the warranty so it's probably best if you have UltraSabers do it. Just contact customer service, they'll give you direction Adding sound to an Emerald led driven lightsaber will be a challenge. You'd need to cut some wiring that go from the card to the battery holder and add some too. This diagram will give you an idea: (https://i.imgur.com/kylYO5Z.jpg) From my 2 Emerald & Obsidian v3 lightsabers I have, US uses a jumper connection between the 2 boards, then wires in the LED module, switch, battery holder and speaker. |