|
Title: Consular green p4 led question Post by: MikeStar007 on May 01, 2013, 06:58:18 PM I recently bought one of these p4 green LEDs. I decided to experiment with it a little and I noticed it got a fair amount brighter when I switched one of the 3.7v 900mah trustfires with a Duracell 1.2 volt 2450mah . So is this ok or will I burn the led out. I'm using
1 trustfire 3.7volt 900mAh ( which I got from ultra sabers) And 1 Duracell 1.2 volt 2450mAh Title: Re: Consular green p4 led question Post by: Master Bluespike74 on May 01, 2013, 07:02:39 PM Mixing Li Ion with Ni MH is probably going to cause one of the cells to explode. I would only use Li Ion with a Li Ion setup. I once attempted to do a voltage check on a Li Ion with a cheapo volt meter powered by a 9V battery. The Li Ion cell became heated in under 15 seconds to the point I couldn't hold it.
Title: Re: Consular green p4 led question Post by: MikeStar007 on May 01, 2013, 07:15:08 PM Wow explode really ? That's crazy. I checked the charge of the trustfire and it was full power same with the duracell .but I will not be doing that again .
Title: Re: Consular green p4 led question Post by: MikeStar007 on May 01, 2013, 07:17:02 PM I'd like to show the result I got to see what you or anybody would think of it . But idk how to post pictures . Help?
Title: Re: Consular green p4 led question Post by: JP47 on May 01, 2013, 10:46:42 PM Here's a link to if you used photobucket :). Create an account there and upload your images and this will show you how to post them
http://www.saberforum.com/index.php?topic=13584.msg208493#msg208493 (http://www.saberforum.com/index.php?topic=13584.msg208493#msg208493) |