Saber Forum

In the video, it was told that the emitter of the battle ready saber was held in by screws, and the normal fallen order saber it's held by pins.

How strong are the pins? If I drop the saber, will it break?

That's a hard question to answer.   I think the only real truthful response is "maybe"?  :-)   If the pins on the Fallen are anything like the claw pins on the Aeon V5, they're pretty strong, but that shroud is far more exposed.  I'd say there's probably a chance that if you drop the saber the shroud might pop off if it is the non-combat version.   There's a far smaller change the combat version will break, but with enough stress or impact even that one could.

Short of doing an actual drop test (which I cannot do, I don't have one to test) I'd maybe pose the question to [email protected] and see if they have anything more definitive?

Aren't the pins made of the same T6 aluminum as the rest of the hilt?  If so, I'd say that breaking them is highly unlikely, although you might knock the shroud loose.

But please note... I SPEAK FROM IGNORANCE HERE, NOT KNOWLEDGE.  Someone with actual knowledge of the subject, please come along and chime in here.

It depends on what you drop it on, from how high, and with how much force.

If you're spinning it full speed, and it goes flying out of your hand, and lands shroud first on the sidewalk, then yes, the shroud might come off. If you're waving it around in the back yard and drop it just on the ground, most likely the shroud will not come off.

Without actively trying to break one, it's unlikely anyone is going to know just how much it takes to make the shroud come off. As was mentioned, you can always contact US directly at either [email protected] or [email protected] .

Or just get the combat rated version and you'll be fine.