Title: Swapping a single LED for a tri-CREE Post by: Maestro Jones on March 14, 2019, 01:08:00 AM If I want to swap out a single LED (AS) for a tri-CREE LED (BR) do I need to add anything else to get the maximum brightness? This would be for a stunt saber with the standard setup (4 AAAA batteries). Do I need a buckpuck or resistors, or can I just swap them?
Title: Re: Swapping a single LED for a tri-CREE Post by: scifidude79 on March 14, 2019, 06:45:27 AM You could use a buck puck if you want to, that will drive the LED more efficiently than a resistor. That would maximize the brightness. Though, it's not necessary just for the LED swap. The resistor that came in the saber will work fine with the Tri LED.
Title: Re: Swapping a single LED for a tri-CREE Post by: Infinit01 on March 14, 2019, 12:48:01 PM What SFD said. A Buckpuck is more efficient but the resistor that comes with the LED will work
Title: Re: Swapping a single LED for a tri-CREE Post by: Maestro Jones on March 14, 2019, 03:15:11 PM Thanks. I have the LED already, but I just wanted to know if there was anything else I needed before I do the swap.
Title: Re: Swapping a single LED for a tri-CREE Post by: scifidude79 on March 14, 2019, 03:52:40 PM Need? No. If you've got the LED, it's just a straight swap. Are there other types of upgrades you can do? Sure, but that's entirely up to you. :)
|