|
Title: my new guardian saber Post by: kazman72 on May 05, 2020, 05:53:49 AM I recently got a Guardian Diamond saber, I had it shipped with an idle pulse but I decided I don't want the pulse so when I open the launcher and go to the Emerald LED driver tab and uncheck the pulse box it isn't letting me save that setting, when I unplug my saber it just defaults back to pulsing this is frustrating because I can't get a hold of ultrasabers they're not answering their phone, and not replying to my emails.
Title: Re: my new guardian saber Post by: Arcinsaw on May 05, 2020, 05:55:14 AM I would recommend watching the how to videos on the website.
Sent from my Redmi Note 7 using Tapatalk Title: Re: my new guardian saber Post by: kazman72 on May 05, 2020, 06:12:31 AM I did but it is no help the tab on the left of the launcher page is not highlighted it's dark and you can't click on it, the write to board tab is what you are supposed to click when you are done and ready to save your changes but for some reason it's not letting me.
Title: Re: my new guardian saber Post by: Arcinsaw on May 05, 2020, 06:31:49 AM You need to read from board first to establish the baseline settings before you can change them. Try that and let me know if it works
Sent from my Redmi Note 7 using Tapatalk Title: Re: my new guardian saber Post by: kazman72 on May 05, 2020, 06:43:48 AM I can't do that either the "Read from board" "Write to board" and the "Driver config" buttons are not highlighted at all for some reason that's the problem I don't understand why they are basically turned off or disabled, the Load Defaults, Load from file, and the Save to file buttons are highlighted and can be selected.
Title: Re: my new guardian saber Post by: Arcinsaw on May 05, 2020, 01:48:03 PM Are you sure the board is connected? Can you change the color and click test to see it?
Sent from my Redmi Note 7 using Tapatalk Title: Re: my new guardian saber Post by: kazman72 on May 05, 2020, 05:09:23 PM yes it's connected.
Title: Re: my new guardian saber Post by: ObitusDator on May 18, 2020, 03:26:11 PM Emerald LED driver tab I realize it's been like two weeks, and you probably already figured this out yourself, but this is your problem. Diamond sabers need to be edited with the diamond controller tab. If you're in the emerald led tab it's gonna be looking for software that isn't there and it won't actually do anything. Title: Re: my new guardian saber Post by: MVHI JEDI on May 19, 2020, 01:09:53 AM Sounds like you're trying to edit Diamond effects with the Emerald editor. Use the Diamond Controller tab.
Title: Re: my new guardian saber Post by: Purzelkater on May 20, 2020, 06:25:18 AM When the saber was found correctly, the software should switch to the Diamond controller tab itself. This is how it works for me. Just my 2 cents. ^^
Title: Re: my new guardian saber Post by: ObitusDator on May 20, 2020, 12:18:24 PM When the saber was found correctly, the software should switch to the Diamond controller tab itself. This is how it works for me. Just my 2 cents. ^^ You're right, it should. But I know the first time I started the program I didn't think the diamond tab looked right, and immediately went to the emerald led tab. After a few minutes of not knowing why it wasn't working, I finally tried the font editor in the diamond tab. |