|
Title: Ultrapixel Stringblade possibilities Post by: OMG_Kenobi on October 03, 2021, 12:17:02 AM Since the contacts/PCB for sending power/signals to the stringblade is a flat disk, has there been any plan to make an Archon V3 Saber with stringblade?
Title: Re: Ultrapixel Stringblade possibilities Post by: scifidude79 on October 03, 2021, 10:55:35 AM People from the company don't frequent the forums, so you may want to contact customer service with that type of question. However, I'd imagine they're working on it.
Title: Re: Ultrapixel Stringblade possibilities Post by: DarthRondoudou on October 05, 2021, 01:53:04 PM So at the moment it's not possible to buy pixel hilts without blades from US, right?
Title: Re: Ultrapixel Stringblade possibilities Post by: scifidude79 on October 05, 2021, 10:27:48 PM So at the moment it's not possible to buy pixel hilts without blades from US, right? Probably not. Last time I looked they don't even offer the Pixel connector for a DIY install. Hopefully that will change in the future. Title: Re: Ultrapixel Stringblade possibilities Post by: nunya on October 06, 2021, 01:19:20 AM Since the contacts/PCB for sending power/signals to the stringblade is a flat disk, has there been any plan to make an Archon V3 Saber with stringblade? That would be great! Looking at that emitter, i really do not see how a pixel blade would be feasible. yes the PCBs are flat but have to be held down. It would take a redesign of the emitter. plus the pixel blades are heavier (want to say 'much heavier' but i have not weight compared yet...) so maybe...but i would not wait around for it. Also, on the site, i can confirm Archon v3.1 is not available with pixel as of today. Title: Re: Ultrapixel Stringblade possibilities Post by: DarthRondoudou on October 06, 2021, 04:32:13 PM Probably not. Last time I looked they don't even offer the Pixel connector for a DIY install. Hopefully that will change in the future. Unfortunate. I would have ordered now.Title: Re: Ultrapixel Stringblade possibilities Post by: nunya on October 13, 2021, 08:06:47 PM That would be great! i found other sites which give the impression that pixel blade is possible in emitters which are similar to the Archon v3.1 so maybe i am wrong on this one. i still do not see how it could be done effectively.Looking at that emitter, i really do not see how a pixel blade would be feasible. yes the PCBs are flat but have to be held down. It would take a redesign of the emitter. plus the pixel blades are heavier (want to say 'much heavier' but i have not weight compared yet...) so maybe...but i would not wait around for it. Also, on the site, i can confirm Archon v3.1 is not available with pixel as of today. |