Bit of a weird one.

[CreepySeagulls]

So, I've been thinking about whether or not I could fit 2 LED modules in one saber. So one at each end, but in a single hilt, rather than a staff. The idea is to have a blade plug in one end, and the blade in the other, but still short enough to weild in one hand.

I wouldn't have sound because I wouldn't be able to fit it in.

I have no real knowledge of saber electronics (or electronics of any kind) as I don't own a saber yet and haven't had a chance to look inside one. So if this is a stupid question then I'm really sorry.

Any help would be greatly appreciated.

[chicago.jedi]

I would think this would work. The RGB sabers are essentially running two or three LED's off one battery set-up. So you should be able to just wire up the two LED modules in parallel off of one battery pack and one switch.

I could be wrong, someone might have tried this already and know differently. But from what I can come up with, this seems very possible. You might need to throw a short extension piece in to give you just a little more room inside.

[Darth Vapour]

Yes it's possible.

[CreepySeagulls]

Awesome. I should have mentioned which saber I was planning on doing it with, it'll bea catalyst, will this me much of a difference? I was planning on having an extension piece or two.

[CreepySeagulls]

Make*

[Darth Vapour]

The only difference the hilt makes is the cram fu factor