What did you make the emitter shroud out of? PVC?
Correct
Here in Germany it is difficult to find a piece of PVC with the right ID. The ID of one I got was about half a mm to small, so some 'fun' hours with file and sandpaper were involved...
Definitely an interesting custom, how did you secure the leather?
I was quite amazed but it doesn't take much:
I used a little sandpaper to rough up the hilt. Afterwards I started wrapping from pommel side; as I used quite a bit of force, that way the wrap is 'fixing' itself. On the emitter side for the last inch or so I used leathercraft cement (this one
http://lederkram.de/lederkram/grosserbilderordner/fiebingslederkleberleathercraftcementneu.jpg) to glue the leather strip to itself. I could have glued more, but as I don't duel, this should be enough for me
Only downside: The tutorial I found for doing such a wrap recommended to use quite a thin leather; the only 'nice one' I got is two or three times as thick
I'd say the Liberator now has the 'regular' MHS OD...