Since it's not standard, it may be helpful to make a list of how deep the blade goes into the different hilts.
We already know the standardized length of the different blade types but the same 32" blade for example will end up in a different "net length" most of the time when it's attached to different hilts.
It was a bit of contemplating for me both times before ordering to decide what blade length I sould order for the best results and had to ask other forum members who had the hilt already to measure the socket depth for me (which they did and I thank them here again
)
So if you agree to help getting these information together and have some time next time you change the blade, please post your results with the specific hilt you measured the socket depth of.
The list so far (all approximations)
Aeon v2:- 2.5" (6.35 cm)
Aeon v3:- 3" (7.6 cm)
Apprentice:- 2.6" (6.6 cm)
Archon v2.1:- 4" (10 cm)
Archon v3.1:- 0.7" (1.7 cm)
Bellicose - 2.4" (6 cm) to bottom of the slant
Catalyst:- 1.75" (4.4 cm)
Consular:- 2.8 inches (7.2 cm)
Dominix V4:- 2.62 - 3.5" (6.6 - 8.9 cm) Possible variation by electronics configuration
Flamberge:- 4" (10.2 cm) on the main blade / .75-1 inch (1.9-2.5 cm) crossguards
Flamberge v2:- 3.5" (8.9 cm) main blade / .75-1 inch (1.9-2.5 cm) crossguards
Initiate v3:- 2.5" (6.35 cm)
Initiate V4:- 2.0" (5 cm)
Liberator:- 2.6" (6.5 cm)
Manticore:- 3.0" (7.6 cm)
Menace - 3.375" ( 7.9 cm)
Overlord:- 2.625" (6.6 cm)
Propecy v3:- 3.14 inches (8 cm)
Scorpion - 3.3" (8.3 cm)
Sentinel:- 2.75" (6.9 cm)
Standard Issue:- 1.9" (4.8 cm) to the bottom of the slant
Thank you!