Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: [1]   Go Down
Author Topic: Ultrasabers Parts Wiring Help  (Read 1113 times)
rdevivo
Force Sensitive
*

Force Alignment: 0
Posts: 2
« on: June 15, 2016, 04:55:52 PM »
I am new to the lightsaber building world and wiring in general. I have my hilt and everything built but am a little confused about the wiring. I have looked at various diagrams and am unsure of the correct one for my parts. I have a buckpuck, an obsidian v4 sound card, a LED module, a momentary switch and all the tools required to wire the saber. I am using all ultrasabers build your own lightsabers parts and was hoping somebody could set me in the right direction to proper wiring or maybe show me some instructions or a diagram.
Logged

fluffySabers
Force Sensitive
*

Force Alignment: -1
Posts: 1
« Reply #1 on: May 14, 2017, 04:42:17 PM »
Yeah, me too. I have been confused
Logged

Racona Nova
Knight of the Obsidian Order
SaberForum.Com Moderator
Knight Commander
*****

Force Alignment: 1116
Posts: 4771


There is no good or evil....there's only power!
« Reply #2 on: May 14, 2017, 05:00:22 PM »
http://www.saberforum.com/index.php?topic=8667.msg127316#msg127316

This applies to all Obsidian boards from v2 to v4.
Logged
Sig by Master Nero
Phantasm v3 LE (Obs v3) - AB w/ FoC AS---Manticore (Obs v3) - BR w/ FoC AS (QD)---Archon v2.1 (Obs v3) - RGBW Emerald

Pages: [1]   Go Up
Send this topic | Print
Jump to: