Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: [1]   Go Down
Author Topic: The different Obsidian board settings and what they affect  (Read 331 times)
Racona Nova
Knight of the Obsidian Order
Knight Commander

Force Alignment: 722
Posts: 3268

Much to learn you still have!

« on: September 24, 2016, 01:24:52 PM »

*Requesting this to be converted into a sticky post (line may be deleted after doing so)*

Since there are more and more questions on what the different Obsidian settings mean and what they affect, here's a short but simple explanation of any of the settings:

Motion Threshold: Overall sensitivity of the motion detection sensor. The lower the number, the more sensitive the sensor is - and the higher is the triggering of fake motion sounds.

Motion Integration Time: Sensitivity of the motion sensor in regards of the above mentioned fake triggers. The lower the number, the more sensitive the saber is and more fake triggers occur. Rising the number lowers the fake trigger chance, but also overall sensitivity. Use this in combination with Motion Threshold to achieve high sensitivity without too many fake triggers.

Impact Thresold: The same as Motion Thresold, only for the impact detection sensor.

Impact Debouncing Time: The same as Motion Integration Time, only for fake triggers of the impact sensor.

Minimum Time Between Impacts: This sets the reset speed of the impact sensor. The lower the number, the faster the sensor can react to subsequent impacts.

Lockup Flash Time (only for Flash on Clash enabled sabers without the Emerald Driver): The simplest of the settings. It controls the speed of the lockup light effects - the higher, the faster.

Phantasm v3 LE (sound) - AB w/ FoC AS
Manticore (sound) - BR w/ FoC AS (QD)
Archon v2.1 (sound) - RGBW Emerald

Pages: [1]   Go Up
Send this topic | Print
Jump to: