Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: [1]   Go Down
Author Topic: Flamberge not working!!  (Read 1481 times)
Rens Fist
Knight Aspirant
*

Force Alignment: -18
Posts: 15



« on: October 07, 2016, 03:34:48 AM »

So I got my flamberge this morning, I went to give the blade a flicker/pulse effect. As soon as I set the parameters, the cross guard blades and the lighted switch went out...

Help me? I can't seem the get them back on. Is it a setting on the saber itself, or in the launcher?

The batteries are fully charged... what I'm also confused about is that the main blade LED works, but the cross guard and the button don't... any ideas?
Logged

Only the best

Racona Nova
Knight of the Obsidian Order
Moderator
Knight Commander
*****

Force Alignment: 1116
Posts: 4771


There is no good or evil....there's only power!


« Reply #1 on: October 07, 2016, 05:57:21 PM »

Check the channel you assigned your switch and side blades to. As soon as you change the setting of this specific channel, it affects the switch and side blades. When you power it (i.e. set a value greater than 0), the blade and switch should light up again.

I suggest checking Channel 4 first, since this is the recommended (and default) option on the customization page Smiley
Logged

Sig by Master Nero
Phantasm v3 LE (Obs v3) - AB w/ FoC AS---Manticore (Obs v3) - BR w/ FoC AS (QD)---Archon v2.1 (Obs v3) - RGBW Emerald

Pages: [1]   Go Up
Send this topic | Print
Jump to: