Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: [1]   Go Down
Author Topic: Bellicose Retention Screw Size  (Read 843 times)
BatMike90
Knight Commander
*

Force Alignment: -793
Posts: 2736


Dark (Knight) Side Points.


« on: January 21, 2017, 04:31:17 PM »

After digging around for some information, I came across the size of allen key I would need for the Bellicose blade holder? Is 1/16th correct?
Logged

Arsenel:
RGBW DIAMOND: Archon v3.1 / Dominicide / Graflex SE /  Guardian
V4 SOUND : Dark Prophecy v3 (x2) / Emperor's Hand
STUNT: Aeon v4 / Bellicose / Dark Apprentice v4 (x2) / Dark Prophecy v3 (x2) / Phantom Initiate V4 / Prophecy v3 / Renegade LE / Scorpion (x2)
Star Wars Cosplay Alias:
Merik Wolfe (Jedi Knight) / Darth Marcotus (Sith Warrior)
BatMike90's Soundfonts

Landen Se-Sentien
Shadow Sentinel of the Manticore Order
Knight Commander
*

Force Alignment: 1828
Posts: 3781


I work in the Darkness in service of the Light


« Reply #1 on: January 21, 2017, 05:09:44 PM »

You need 3/32.
Logged

Signature banner by DarthScrub

BatMike90
Knight Commander
*

Force Alignment: -793
Posts: 2736


Dark (Knight) Side Points.


« Reply #2 on: January 21, 2017, 06:34:12 PM »

You need 3/32.

Thank you for the response but I have gotten myself confused somehow. I have the standard allen key, which size do I need to access the screws on the blade holder?
Logged

Arsenel:
RGBW DIAMOND: Archon v3.1 / Dominicide / Graflex SE /  Guardian
V4 SOUND : Dark Prophecy v3 (x2) / Emperor's Hand
STUNT: Aeon v4 / Bellicose / Dark Apprentice v4 (x2) / Dark Prophecy v3 (x2) / Phantom Initiate V4 / Prophecy v3 / Renegade LE / Scorpion (x2)
Star Wars Cosplay Alias:
Merik Wolfe (Jedi Knight) / Darth Marcotus (Sith Warrior)
BatMike90's Soundfonts

Landen Se-Sentien
Shadow Sentinel of the Manticore Order
Knight Commander
*

Force Alignment: 1828
Posts: 3781


I work in the Darkness in service of the Light


« Reply #3 on: January 21, 2017, 06:47:20 PM »

There are 3 retention screws. Two hold the blade inside the blade holder. One holds the blade holder in the emitter.

The two that hold the blade inside the blade holder use the standard 5/64 hex wrench.

The one that holds the blade holder inside the emitter uses a 3/32 hex wrench.
Logged

Signature banner by DarthScrub

Pages: [1]   Go Up
Send this topic | Print
Jump to: