Have had my Lost Gray upgraded to Diamond, and whilst I'm mostly happy with it, I'm getting pretty frustrated with some of the effects not working after saving them.
For example, I click on Edit Effect, add sound(s) and LED effects, test them, they work fine, so I save the effect. Then I go back to Font Selection, click on Load Effect, click on the effect I just saved, and when I go to test it, nothing happens. So I click on Edit Effect again, then get a message "Cannot read file xxxx.wav: Does not exist or cannot be opened"
I've used Goldwave to save the sound files as Mono 48000 Hertz Uncompressed wav files, but still no joy - getting a little peed off with it now, to be frank
I feel the same my fellow Jedi. Here is a copy below of a post I made in another thread. I'm trying to be patient because the software is so new and they need some time to work out the bugs. Hopefully it will only get better.
I was wondering if anyone has experimented with creating and saving Diamond fonts without the saber plugged in so that these fonts could be loaded quickly and easily into the saber at a later time. Here is what I did.
1) I opened the Ultrasabers Launcher as administrator and then click the Diamond Tab.
2) I click on the font editor tab and then click the load font tab
3) I load one of the Default fonts such as the standard Obsidian font.
4) I then choose an effect from the column list on the left (Tag effect, Power on effect, etc..) and click the Edit Effect button.
5) I then make some edits to the lighting effect and I also delete the existing Sound effect and upload a new Sound Effect.
6) I then rename the effect and click the Apply to Font tab
7) I then exit the Effect Editor and go back to the Effects Wizard and choose the next effect and repeat steps 1-7.
Lastly, I select the Write Font tab on the left side and then click the Save Font button on the lower right.
9) I name the font I just created and then I save the .pfnt file to a folder of my choice.
The problem I am having is when I later go to load the font and write it to the saber, some of the sound files that I attached to the effects don't show up.
The sound files for the Tag, Power on, Power off, Idle, Force, and Gesture are just not showing up. When I click on the Edit Effect button, an error message saying "Cannot read file- Does not exist or cannot be opened" pops up. The sound files for all the other Effects, however, do show up fine.
Has anyone else tried this and experienced the same issue? It would be nice to be able to edit/create fonts and then save them for later use without the saber plugged or having to write them to the saber straight away.