Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: [1]   Go Down
Author Topic: Aeon Saber question about sound  (Read 2370 times)
Sythen
Knight Lance Corporal
*

Force Alignment: 0
Posts: 52


A Jedi uses to force for knowledge and defense..
« on: December 27, 2010, 02:06:06 AM »
I have a SRD Aeon and it is fantastic and the review is coming in a few hours. I do have one question.
I am planning to install my own FX sound card and it is all ready to go but i have a slight problem.
How do i get  the electornics in the hilt out.
« Last Edit: December 27, 2010, 02:09:13 AM by Sythen » Logged
█||∥∦∥∦∥∥∥|⊂◅⊃Pך   

Mikkyo of the Sith
Knight Apprentice
*

Force Alignment: -4
Posts: 24
« Reply #1 on: December 27, 2010, 07:27:01 AM »
I have a V2 Phantom I was curious about doing this to as well. & I didn't want to start a whole new thread, but A: what size is the illuminated hole in the emitter & IS it threaded?
Logged

Ultra
Lord Commander
Administrator
Knight Commander
******

Force Alignment: 1765
Posts: 2194


IN HOC SIGNO VINCES


WWW
« Reply #2 on: December 27, 2010, 09:36:34 AM »
The decorative hole in the emitter is 6-32 threaded.  You can leave it as-is, or add a decorative thumb screw.  For liability reasons, we do not encourage nor provide instruction on the disassembly of our sabers, however, I'm sure you can figure it out on your own as it's not too complicated.
Logged
-Ultra
http://www.ultrasabers.com

Pages: [1]   Go Up
Send this topic | Print
Jump to: