How do I clean nickel plating on my CE sabers?

[ThreadJack]

I've seen this question a few times, so I figured I'd post a sticky thread. None of this is saber specific, but there are some general methods to cleaning nickel plating without damaging the finish.

https://m.wikihow.com/Clean-Nickel-Plating

I would suggest buffing it down with soap and water(method one above) before trying any chemicals. Just be sure to use WARM(not hot) water, gentle dish soap(I'd recommend Dawn), a non abrasive cloth, and gentle circular motions. This method should be enough to remove the fingerprints often associated with plated hilts, I wouldn't imagine them getting soiled enough to where chemicals are needed.

[Infinit01]

Good idea on opening a new thread, TJ. 

[ThreadJack]

Good idea on opening a new thread, TJ. 

I figured it was a worthy use of forum space!

[Sinaedus]

You can also use faucet polish on old sabers to clean them up and restore shine. Makes new sabers shinier than before as well.

[MVHI JEDI]

I've seen this question a few times, so I figured I'd post a sticky thread. None of this is saber specific, but there are some general methods to cleaning nickel plating without damaging the finish.

https://m.wikihow.com/Clean-Nickel-Plating

I would suggest buffing it down with soap and water(method one above) before trying any chemicals. Just be sure to use WARM(not hot) water, gentle dish soap(I'd recommend Dawn), a non abrasive cloth, and gentle circular motions. This method should be enough to remove the fingerprints often associated with plated hilts, I wouldn't imagine them getting soiled enough to where chemicals are needed.

The pre-packaged cloth wipes for cleaning electronics and computer screens work AMAZING!!!