Click here for lightsabers
  • Home
  • Help
  • Login
  • Register
Pages: 1 [2]   Go Down
Author Topic: Dominicide LE review simplified  (Read 260 times)
Lady Revan
Knight Commander
*

Force Alignment: -954
Posts: 2345


I leave my alignment to Fate-whether Light or Dark


« Reply #15 on: August 13, 2019, 05:46:30 PM »

Is this ok?



Note: On the Shock LE emitters, I have a 3 inch blade plug installed in each, flush to the top. The bottom rests against the LED Module after I pushed it down and tightened the set screw holding it in. The Dominicide clawed emitters are only about 1 inch in depth, so that 1/4 inch showing on the Shock emitters does help a little.

That's perfect! Thank you! Was curious how the claws looked up close.
Logged

My Sabers: I'mma make a link eventually. list doesn't fit in sig any more Sad

Author of: Only Light Can Cast Shadow A pre-KotOR Fem!Revan Fic

Twisted Morality (Part III of "Only Light Can Cast Shadow")

I leave my alignment to fate--Light or Dark

Lady Revan
Knight Commander
*

Force Alignment: -954
Posts: 2345


I leave my alignment to Fate-whether Light or Dark


« Reply #16 on: August 13, 2019, 05:47:14 PM »

Sorry, the post seems to have sent twice (I had a connection issue). Can a mod please delete this? Thanks!
Logged

My Sabers: I'mma make a link eventually. list doesn't fit in sig any more Sad

Author of: Only Light Can Cast Shadow A pre-KotOR Fem!Revan Fic

Twisted Morality (Part III of "Only Light Can Cast Shadow")

I leave my alignment to fate--Light or Dark

Duff Man
The Double Triple X 4 + Fish OG of Randomness Version 2.7 of part 9 = Bacon
Knight Commander
*

Force Alignment: -338
Posts: 1465


« Reply #17 on: August 13, 2019, 07:57:54 PM »

The Middle Grips looked like they are too thick/raised to high for a comfortable and smooth transition.   but that is just based on the pics, plus some  bias on my part. I have never been a fan of those rubber wiper style grips.  But then neither  was  Mark Hamill or Hayden Christensen 
Logged

Ultra Saber SI Staff:Guardian Blue
Ultra Saber Redemption:SRD
Ultra Saber Dominix V2 LE:Dark VA
MR Construction Kit:RGB

chalion
Knight Commander
*

Force Alignment: 181
Posts: 724



« Reply #18 on: August 14, 2019, 02:47:22 PM »

The Middle Grips looked like they are too thick/raised to high for a comfortable and smooth transition.   but that is just based on the pics, plus some  bias on my part. I have never been a fan of those rubber wiper style grips.  But then neither  was  Mark Hamill or Hayden Christensen  

Since the grips are in the middle it's not as bad. The Electrum Wind has the same grips and is about a wide - about the same width as my US Graflex lightsabers too, but the Graflex are plastic, the grips on the Dominicide and EW are aluminum.

Note: THe grips are held in by the now normal roll or spring pins, so if you so desired, you could probably hammer them out and remove the grips. I believe the grips are there for 2 reasons: a) decoration b) to give extra support to the chamber section. The way the set screws are used to attach the center, I believe someone who's enterprising & savvy enough could make a replacement section to replace the one that exists now, with a smooth exterior. Which could be longer or shorter too.
Logged



22 diamond lightsaber and counting

Pages: 1 [2]   Go Up
Send this topic | Print
Jump to: