So the first Horn is halfway done, Atleast as far as resin coating is concerned:
Next up, I'll get the other Horn to that same stage, asuming i can recover it from a number of seams breaking open as i applied the first layer of fiberglass. Lesson learned: always make sure the Pepakura is still Holding firm before working with it.
As for the fabric parts, Both the linen lining and the faux fur parts are cut.
Nothing to fancy pattern wise, the big piece in the back is a half-circle cloak, to cut one your self simply draw a half circle on a piece of fabric, idealy with a radius = width of the fabric. You can always trim it later if That's too short.
The quartercircles in the relativ Center of it will Form the hood, those were simply measured to fit the neck cut out in the larger half circle. (which as this Thing should in the end
also fit my mando was easy to measure with the helmet for that kit:
(note i forgot to take a pic imediatly, so the helmet got bumped around abit before this picture)
The long Strips I'll be adding to the Front to add a counterweight for when the whole Thing hangs mostly from my shoulders/neck, and Potentialy to tie it closed.
Before i continue there though i need to finish the horns to a point where i can measure out their rough Positions and the holes to fit them. As well as the teeth i want lining the hood and then i can sew it most of the way together.