Hey folks, newbie question:
I've had my Initiate V4 stunt for a while and am finally going to start fiddling with the electronics. Naturally, I'm hesitant because I don't want to break anything if I don't have to, and I can't seem to find anything specific on how to remove my LED, being that this is a solid hilt without an MHS emitter.
Would I just remove everything from the pommel upward (battery pack, switch, LED)? And if so, how is the LED affixed inside? I know the switch is glued in, but is the LED just free floating or will I have to rough it up to remove it?
Thanks!
Hey Dex!
The LED in the V4s is free-floating and should slide right out. the biggest issue I can think of would be the choke points, it may need to slide out the emitter.