Points incoming, will look at them later. (Just here for a quick update.)
Update:
Great video's! Can't say thank you enough!
And if I'm not mistaking, does this mean I can actually install a switch that will light up on my stunt Aeon?
Does that bevel ring come standard with the switch from TCSS?
And have you mentioned the kid of resistor I need in the movie? (I forgot....)
This is going to be a real fun project!
Thanks Firehand!
Yes you can add a lighted switch in a stunt by using that little circuit card I had there. They are just under $5 at TCSS. The ring does not come standard it's a separate purchase and actually costs slightly more than the switch. These videos are only for replacing the guarded switch so an Aeon with one should have the recessed switch hole and not need the ring. The sabers I'm going to do later today are that way. The specific resistor you need varies by power source and LED in the switch, the one I used. The ones I used were 430 Ohms. They are much more than needed but safe for the LED and I had them laying around. You could use 150 for cooler colors to 175 for warm colors depending on LED color.