Hello!
I recently upgraded my Lightsaber to include a soundboard and speaker! (I already had the flash LED but it wasn't connected). After following the 4th wiring diagram on this forum:
http://www.saberforum.com/index.php?topic=42841.msg732779#msg732779I found the lightsaber makes sound perfectly, but the LED's are not functioning properly. When I ignite it, the main LED flashes for about half a second before turning off again. If I shake it, I can make the clash LED flash as well but only in that half-second before the main LED turns off. Heres the values I used for the build:
Main LED: Green
Clash LED: Orange
Buckpuck: Originally 350 mA, then upped it to a 1000 mA with no success (but the speaker is quieter now)
https://www.amazon.com/gp/product/B00LWU0U3Y/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1Resistor: 1.1 Ohm (I plan on switching it out for a higher value as to not burn out my accent LED, but I don't think that would cause the other LED's to function as they are)
Does anyone know why I have this issue? I was thinking maybe the buckpuck was still not high enough grade, but I'm not sure...
Thank you!