|
Title: Fixing the blade film Post by: Warlock Umbra on May 14, 2011, 10:16:19 PM The film inside my Ultraedge blade has (for lack of a better description) "rippled up" at the bottom. The glue is still intact. I was wondering if there was a way to fix it without having to send it in? Thanks for any help! :)
Title: Re: Fixing the blade film Post by: ThreadJack on May 14, 2011, 11:14:07 PM Beat it against the arm of the couch.
Title: Re: Fixing the blade film Post by: Ex Nihilus on May 14, 2011, 11:41:19 PM The film inside my Ultraedge blade has (for lack of a better description) "rippled up" at the bottom. The glue is still intact. I was wondering if there was a way to fix it without having to send it in? Thanks for any help! :) Mine was the same way... it had the ripple effect going almost all the way up the blade. Ultra said the best way to work it out is to beat it against the arm or cushion of the couch. The other way to fix it is just to keep dueling with it, it'll work itself out. Title: Re: Fixing the blade film Post by: Warlock Umbra on May 15, 2011, 01:23:22 AM Thanks guys! That helped quite a bit, but I don't know if I'll be able get it back to where it was. The corner of the seam came out of the glue. :-\
Title: Re: Fixing the blade film Post by: Ex Nihilus on May 15, 2011, 05:16:51 AM Thanks guys! That helped quite a bit, but I don't know if I'll be able get it back to where it was. The corner of the seam came out of the glue. :-\ In that case, you can take an exacto knife, cut the glue, reset the film, and then re-glue it. Check out this thread: http://www.saberforum.com/index.php?topic=323.0 (http://www.saberforum.com/index.php?topic=323.0) |