|
Title: Latching Illuminated Switch Question Post by: AlthaxX on May 19, 2013, 12:09:18 AM I am about to order a replacement for my busted switch on one of my dominix's i just wanted to make sure it would work.
this is the switch i am going to order: (http://i416.photobucket.com/albums/pp244/Althaxx11/KGrHqFHJCcE7y5w0Ve7BOIdOhw-g60_12_zps14041ff0.jpg) (http://s416.photobucket.com/user/Althaxx11/media/KGrHqFHJCcE7y5w0Ve7BOIdOhw-g60_12_zps14041ff0.jpg.html) it says it is a "Brass 16mm Push-button Switch w LATCH 1NO/C 12V" my dominix is a standard setup with a GB led. my question is when i wire this switch in will i need any special resistors with it or anything? thanks in advance for your help. Title: Re: Latching Illuminated Switch Question Post by: Vex on May 19, 2013, 12:39:07 AM You will need a resistor and a AV switch bezel.
Title: Re: Latching Illuminated Switch Question Post by: AlthaxX on May 19, 2013, 01:03:19 AM what exactly is a AV switch bezel.
Title: Re: Latching Illuminated Switch Question Post by: mcnaughtonM on May 19, 2013, 01:18:46 AM You will need a resistor and a AV switch bezel. If you have a hilt that has taken a guarded switch before, will you still need a bezel if it has the drop for the switch? Title: Re: Latching Illuminated Switch Question Post by: Zren Tobas on May 19, 2013, 03:30:11 AM If this works out for you let us know the info. o_o This gives me ideas. Lol. Or just get a non illuminated av switch unless you want it lit.
Title: Re: Latching Illuminated Switch Question Post by: Kyaryo Ysoyav on May 19, 2013, 05:48:10 AM You might want to cross check the length of that switch with the ID of your saber. My wife has a dominix and they are not as wide as a lot of other sabers. They do make most of these AV switches in a shorter version.
Title: Re: Latching Illuminated Switch Question Post by: AlthaxX on May 19, 2013, 01:48:19 PM Thanks for the info, I am going to order it and give it a go. Ill make a thread about the process and if it works when I recive it.
|