|
Title: US BLades and MHS Parts Post by: Machinimax on June 10, 2011, 05:48:39 PM Does anyone know if Ultra Saber blades are compatible with MHS blade holders from TCSS? Thanks!
Title: Re: US BLades and MHS Parts Post by: Evesbane on June 10, 2011, 06:14:47 PM If you go to the build it yourself section, you can try and find your hilt there. In the description it usually says MHS compatible or not.
Title: Re: US BLades and MHS Parts Post by: ThreadJack on June 10, 2011, 06:19:43 PM Simple answer: Yes.
Title: Re: US BLades and MHS Parts Post by: Warlock Umbra on June 10, 2011, 06:22:10 PM Simple answer: Yes. Some of the TCSS emitters (blade holders) are for 3/4" blades. Title: Re: US BLades and MHS Parts Post by: ThreadJack on June 10, 2011, 06:29:31 PM Some of the TCSS emitters (blade holders) are for 3/4" blades. Ahh, but now you're getting into specifics. :) Title: Re: US BLades and MHS Parts Post by: Warlock Umbra on June 10, 2011, 06:37:18 PM Ahh, but now you're getting into specifics. :) Just wanted to make sure anyone ordering one, "looked before they bought", so they didn't get the wrong emitter. :) Title: Re: US BLades and MHS Parts Post by: Darth Wraith on June 10, 2011, 08:35:27 PM Simple answer: Yes. Agreed, yes, I have used a few with my sabers built from MHS parts, no problems at all ;D . I prefer to use Ultrablades with All My Sabers ;) Title: Re: US BLades and MHS Parts Post by: pandatrooper on June 20, 2011, 10:42:30 PM I have a couple of Ultrasabers with Ultraedge blades, but the blades don't fit into MHS blade holders (blade is slightly too thick). Are you sanding them down to fit?
Title: Re: US BLades and MHS Parts Post by: ThreadJack on June 21, 2011, 01:09:40 AM For some reason the Ultra Edge blades are slightly thicker than the standard Ultra Blade. So yes sanding it down a bit, will get it in your MHS emitter.
Title: Re: US BLades and MHS Parts Post by: pandatrooper on June 21, 2011, 01:36:05 AM Awesome, thanks for confirming!
|