Saber Forum

I have been trying to adjust the sensitivity for impact/spin/and stab on my Diamond Graflex CE for a while now, and it seems that regardless of which way I change the sliders, it doesn't seem to make a lot of difference. So I just want to verify that I'm doing this right. The higher the number on these settings means the higher the tolerance and less sensitive it will be, right? Thanks in advance for the help.

I was under the impression it was the opposite.

The lower the number, the lower the sensitivity.  If I put stab to the highest number it goes off every time I move my saber. If I put it on the lowest number it goes off only if I stab.
 I wish I could make it less sensitive! Especially for stab and spin.

This is correct.  Higher means more sensitive, lower means less sensitive.  It's just like the color sliders.  The higher the number, the more that color is present, the lower the number the less that color is present.  I've had issues adjusting the impact/spin/stab/swing/etc. setting on my Diamonds.  I think it was an issue with saving it to the board.  Eventually, I got it right but I don't know if I did something different or if it just decided to cooperate.  Sometimes I swear my Diamonds have a mind of their own when trying to change settings. 

Thanks.

I'll get them cranked back down to the other end. Last time I went in that direction, it didn't seem to work. But I'll try it again. I'll also play with one of the other Diamond Sabers we have, it could be just this one. Which would be a disappointment cause it's 2 years old and I think that's out of warranty.