Saber Forum

So I bought a dual sided saber without sound and after seeing the quality of the saber I would now like to upgrade it with an Emerald driver with clash and all that does anyone know what the correct components are for me to upgrade my current saber? I’m new to the light sabers and all that but I’m fairly techie so can figure it out once I have the correct components needed.


Sent from my iPhone using Tapatalk

You need this:

14500 Li-Ion battery holder/speaker combo
2x 14500 Li-Ion batteries (XTAR or TrustFire recommended)
Vented (!!) pommel
Emerald Driver
Obsidian Sound board v4
Momentary switch (either metal AV or plastic guarded)
Optional: Resistor for switch LED (if you take an illuminated AV switch)

However, depending on the hilt, you might not be able to have both in one saber. If your hilt does not show the option "Emerald & Sound" in the webshop, it's not compatible due to internal size limitations. If that's the case, your only option would be adding a Diamond board instead of Emerald and sound. Diamond actually combines both boards, thus adding all their features to any saber.

Thanks for the blazing fast response! I actually didn’t have the option for an Emerald driver so I’ll have to go with option two the Diamond board it looks like.

So my shopping list should look like this then? And they’re all available from ultrasabers?


14500 Li-Ion battery holder/speaker combo
2x 14500 Li-Ion batteries (XTAR or TrustFire recommended)
Vented (!!) pommel(is the vent for clearer sound?)
Diamond board
Momentary switch (either metal AV or plastic guarded)
Optional: Resistor for switch LED (if you take an illuminated AV switch)

Lastly I keep seeing comments about quick connects for duel sabers I imagine this is for what it sounds like a quick way to connect and disconnect the sabers correct?


Sent from my iPhone using Tapatalk

Wait... You said there is no option for Emerald?  Or is there no option for Emerald with sound?  Is there an option for Diamond, then?  Which hilts are you planning to use?

You can get all parts from UltraSabers. For the board(s) you need to contact them directly via [email protected], though. They're normally not sold from the webshop (except for the sound).
And the vented pommel is important for the speaker, as the sound can be so powerful that the speaker can become damaged when you use a solid pommel with the volume at 100%.


What you mean is the Quick Disconnect Vented Coupler. Yes, that's suitable for any MHS saber (all sabers except for the v2 models) to make a staff that can be turned into two separate sabers without having to unscrew the coupler from the hilts and putting the pommels back on.

There in lies the problem. I cant seem to get ahold of anyone at ultrasabers ive been trying for three weeks now with no answers i even tried calling a coupl times.. So im stuck till they respond.


Sent from my iPhone using Tapatalk

Try FB messaging them with a detailed message, but not too long.

Someone finally got back to me. Looks like the hilt I ordered is too small in diameter to accommodate the sound board. It’s all good though, I just bought another one 😆


Sent from my iPhone using Tapatalk