These look awesome! I really like the grip on the Aeon... Could you post a tutorial or something?
Aeon CE Simple Mod.
a. #17 O-Rings - Home Depot has them in boxes of 10 in the sink repair section. Recommend getting two boxes.
b. #18 O-Rings - "
c. Black Electrical Tape
d. 8/32 knurled machine screw (silver)
Step 1 :: Add the O-Rings to the small section between emitter and switch section. Alternate sizes like 17,17,17,18,17,17,17,18 (the 18's are thicker and should fit in the grooves. 17's fill out the sections in between the grooves).
Step 2 :: Remove top retention screw. Replace with 8/32 knurled screw (I cut mine down to fit snug).
Step 3 :: Remove pommel. With the Black Electrical tape, start wrapping hilt from the first O-ring and tightly wrap it, avoiding bubbles or creases. Wrap all the way down and cover the last groove near the pommel.
Step 4 :: Slide O-rings 18, 17, 17, 17, 18 down to the switch section and add them until you hit the first groove.
Step 5 :: Finish adding #18 O-Rings and slide them down over the tape and fit them into each groove toward the pommel. Use your hand to apply pressure until they are snug in the grooves.
Step 6 :: On the pommel piece, slide one of the #17 O-rings over the grooves until the grooves come through. Then simply screw the pommel back in place. This creates the "black" spacer between the pommel and hilt section.
Hope this helps!
