Just thought I'd share this for anyone who doesn't like to do perma-mods to their sabers but would like a belt clip without having to have a covertech wheel.
This is just a simple mod using a picture holder d-ring
Take your pommel and belt clip to the store with you to make sure you find the right size for your pommel and belt clip.
And a wire rope clamp
I used a 3mm size, again, take your pommel to the store so you can check before you buy.
Work out what direction you want it to point in before you remove the pommel and just mark it with a pencil or something else easy to clean off. Take your pommel off then lay your d-ring on top over whatever holes you need to use and put the u-bolt half of the clamp through the hole in your d-ring, going from the base of the pommel to the inside.
Hold the d-ring and u-bolt with your finger, or tape it up to make sure it doesn't fall out, then flip your pommel over and use some long nose pliers to put the rope guide part of the clamp, onto the u-bolt. FLAT PART FACING UP TOWARDS YOU. Use the long nose pliers to put the nuts onto the u-bolt and start the thread so they bite, then tighten with a deep socket and ratchet wrench.
If you want, you could also put a second nut on each side of the bolt to make sure they won't vibrate loose while dueling, or even use some thread tape or thread locker.
That's it. Simple. Done.
Clip it onto whatever belt hook you have and enjoy!
