So, something has happened with the Obsidian v4 soundboard on my Archon v3.1 that I received on the 10 of August. And I could really use some help in troubleshooting it.
This afternoon, I reformatted the memory to go from the 4 banks I had been using to 5, so that I could reload one of the Ep VI font. Everything seemed to go okay with the format, I loaded the first bank with my current favorite – LukeROTJNinjaJesus – and stepped away cause sometimes these take a while.
When I came back to the computer, everything looked fine, the US launcher was back at the Obsidian Tab like normal after finishing loading a font. I disconnected through the launcher, turned it off, removed the USB cable, and powered it on to check it.
Except when I power up the lightsaber, it is making a series of different sounds – almost as if it is trying to play all of them at once. It’s really hard to explain – Here is a short video so you can see/hear what it is doing -
https://www.youtube.com/watch?v=xNPMOfO7YMY And it is doing this with every font that I load.
Here’s what I’ve done so far troubleshooting:
1) Reformatted the memory again (actually about a dozen times now)
2) Tried a fully charged set of batteries
3) Checked for firmware updates
4) Re-installed the Ultrasabers Launcher
I’m pretty much out of any additional ideas. I’ve never had anything like this happen, and we have 1 Obsidian v3, 3 obsidian v4s. an Emerald w/Obsidian v4, and 3 Diamonds. I’ve done a lot with all of these, so I’m pretty sure it’s not some kind of newb mistake.
So I’m looking to the community for help. I really hope that this is something that I can solve myself.
Thanks.